Services

Every discipline below is engineered to recognised international standards, adapted honestly to Nigerian site, utility and climate realities — and documented so another engineer could take over tomorrow.

M1 · Mechanical & HVAC-R Engineering

• Thermal load calculations — cooling/heating load modelling in Carrier HAP using ASHRAE RTS methodology, checked against manual estimates
• HVAC systems — VRF/VRV, chilled water, AHUs, FCUs, split/packaged systems, precision air conditioning (PAC) for data centres
• Industrial services piping — hydraulic sizing and stress analysis for steam, chilled water, compressed air and process wastewater networks
• Ventilation — IAQ design to ASHRAE 62.1, kitchen extract and make-up, car park and smoke-control ventilation

E2 · Electrical Power & Low-Voltage (ELV)

• Power reticulation & substations — MV/LV layouts, transformer sizing, power-factor correction, switchgear design
• LV distribution (BS 7671) — connected load schedules, maximum demand, cable sizing, voltage-drop and short-circuit fault analysis
• Emergency power & solar — standby diesel generators, UPS systems, grid-tied and hybrid solar PV with energy storage
• ELV & life safety — addressable fire alarm (NFPA 72), CCTV, access control, structured cabling, public address and BMS

P·F3 · Plumbing, Public Health & Fire-Fighting

• Water systems — borehole and treatment, boosting and storage, hot and cold reticulation, loading-unit hydraulics
• Drainage — soil, waste and storm systems, septic tanks and soakaways, pumping stations
• Fire-fighting water — hydrants and wet risers, sprinkler systems (NFPA 13), fire pump sets (NFPA 20)

PC4 · Project Controls & Management

• Programme planning and MEP scheduling for services installations
• BIM-led coordination to ISO 19650 — federated models, clash management, builders-work schedules
• Cost control, progress measurement and reporting — governance before construction begins

CX5 · Commissioning & Contracting

• Commissioning — plans, pre-commission verification, witnessed static and dynamic tests, TAB, integrated systems testing, seasonal follow-through
• Specialist contracting — supervision, installation QC and handover documentation for services works
• Compliance pathway — authority submissions, NEMSA certification coordination, fire-safety clearances, certificates of completion

How we engage